Wall Removal
Load bearing and structural wall removal done with the ceiling still attached — temporary support, correct beams, proper load transfer.
Most people want to remove a wall because they want open-plan living. That's a reasonable want. The unreasonable part is when the ceiling decides to follow the wall down.
Load path is everything. Before any wall comes down, the loads above it need somewhere to go. That means understanding what the wall is carrying, what sits above it, and what the permanent solution looks like — before the first cut is made. We work from engineering documentation. We install correct temporary support. We do not start swinging hammers and figure it out as we go.
The permanent beam is specified by an engineer, sized for the span and the load, and installed with the correct bearing lengths and connection hardware at each end. The surrounding structure — ceiling, floor, adjacent walls — is made good as part of the scope, not left as someone else's problem.
Non-structural internal walls are simpler, but they still need to be done correctly. Services need to be identified and relocated. Make-good to ceiling, floor, and walls needs to be clean.
What's Included
- Load path assessment before any wall is touched
- Temporary propping and support systems installed first
- Engineer-specified beam and post installation
- Correct bearing lengths and structural connection hardware
- Head and frame trimming to new opening dimensions
- Make-good to surrounding ceiling, floor, and wall structure
- Non-structural internal wall removal
- Services identification and relocation coordination
We provide wall removal across Sydney. Select your area for local information.
Frequently Asked Questions
How do I know if a wall is load bearing?
A wall is likely load bearing if it runs perpendicular to the floor joists above, sits over a beam or foundation below, or has point loads from structure above. If you're not sure, engage a structural engineer before touching it. We've written a full guide on how to tell if a wall is load bearing — worth reading before you start pulling things apart.
Do I need an engineer for load bearing wall removal in Sydney?
Yes. An engineer needs to specify the beam size, bearing lengths, and connection hardware. Anyone removing a load bearing wall without engineering documentation is taking a risk — and it's a risk that stays in the building permanently.
How long does wall removal take?
A single load bearing wall removal including temporary propping, beam installation, and structural make-good typically takes two to three days. Non-structural walls are faster — often one day.
How much does load bearing wall removal cost in Sydney?
Roughly $3,000–$8,000 for a standard load bearing wall removal including temporary propping and beam installation, depending on span, beam size, and complexity. Engineering fees are separate. Contact us for a site-specific quote.
Can the ceiling stay up during wall removal?
Yes — that's the entire point of temporary support. The loads above are transferred to props before any structural member is cut. If someone is removing a load bearing wall without propping the ceiling first, stop the job and call someone who knows what they're doing.
Other Services
View AllWall Framing
Structural wall framing where every stud is checked, every plate is straight, and every fixing is done twice.
Subfloor Framing
Squeak-free subfloors built on a level datum — because squeaking floors are a construction failure, not a maintenance issue.
Roof Framing
Roof structures framed straight, set with controlled pre-camber, and fixed so they stay that way under load.